>Plugging an intact pin block is often my choice, especially with open-faced >types. I use 3/4" plugs so that they interlock. Once that is accomplished, I >veneer over the plugs with something like birdseye maple. It is really nice >looking and has an original finished look about it. The trick is in the >"fixture" needed to do all the drilling. >Best Regards, >Joe Garrett, RPT, (Oregon) I've done this with 1/2" plugs and veneer overlay. Drilled with the same setup I normally use drilling pinblocks in the piano. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC