When I sort tuning pins, it usually takes two sets to make one complete set of the specific size. Also, I wind up with about 20 or so that are under size and the rest are oversize. In 2/0 sets of pin, (.282"), I have seen pins as large as .286", (3/0)! And as small as .279", (1/0)! Some sets are very consistant and accurate, others, not so good. And it doesn't seem to make any difference who made them, either. Regards, Joe Garrett, RPT, (Oregon) I'm never lost, because everyone is telling me where to go. <G>
This PTG archive page provided courtesy of Moy Piano Service, LLC