Delignet et al

[Joseph Garrett]

Speaking of Pin Block Material, <G>, I need more scrap. If any of you have
scrap pinblock material, laying around, I'll be happy to take it off your
hands. Any type pinblock material is ok, but I do prefer Delignet. However,
beggers can't be chosers. The last time I made this request I got some from
Newton, (Thanks buddy!), and from the rebuilding facility in Juarez, ( I
lost his email address due to a computer event! :-())
For those inquiring minds, I use the scrap to make 3/4" plugs. I use them to
restore pinblocks on the ultra difficult type pin blocks, etc. Anyway,
responses will be gratefully accepted. I will pay postage and/or cost if you
so desire.
Many thanks,
Joe Garrett, RPT, (Oregon)