Hi Ron. Bill Spurlock recommends adding 1/16" shank length for each of the last five hammers in the low tenor if one wishes to improve damper clearance. So the last tenor hammer would be only raised 5/16". I see another post that indicates Mr. Spurlock recommends adding 1/8" per hammer - I got my info from the instruction sheet he mailed me with my new Spurlock hammer hanging jig. Terry Farrell ----- Original Message ----- From: "Ron Nossaman" <RNossaman@KSCABLE.com> To: <pianotech@ptg.org> Sent: Friday, November 09, 2001 8:25 AM Subject: Re: C88 Hammer Position > >This original hammer line > >was straight, but I plan on raising the last few tenor hammer to accommodate > >longer dampers. Do you know of any trouble with this design? Thanks > > > >Terry Farrell > > Raise them how much? The strike point change probably won't make a whole > lot of difference that low in the scale, but it wouldn't hurt to dry fit > test it first and determine that before it's glued in. > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC