This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Carefully measure the width and height of the agraffe extension and pay = a visit to your local machine shop. Have him/her cut an appropriate slot = in the end of a 1/2" steel rod and mill a square or hex -- your choice = -- on the other end. If this is a tool you'll be using from time to time = you might want him/her to harden it a bit. -- ddf -------------------------------------------------------------------------= ------- ----- Original Message -----=20 From: David Love=20 To: Pianotech=20 Sent: July 19, 2094 11:07 PM Subject: Agraffe Wrench Any of you tool makers out there have an agraffe wrench that will = accommodate a .220" deep agraffe? Please reply on or off list. David Love davidlovepianos@earthlink.net ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/ee/ad/d3/79/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC