Those were not mine Clyde Joe Goss imatunr@primenet.com http://www.primenet.com/~imatunr/ ----- Original Message ----- From: "Clyde Hollinger" <cedel@supernet.com> To: <pianotech@ptg.org> Sent: Thursday, January 25, 2001 5:11 AM Subject: Re: Tuning Lever Ball > Dave, > > At the exhibitor where I saw these, the hole in the ball was way too big to > fit well on any of the tuning hammers that were on display. I pointed this > out to the salesman and also to several standers-by, and no one knew what to > say. So be sure to get one that fits right. > > Regards, > Clyde Hollinger > > Dave Hall wrote: > > > Hi list. > > > > At the last convention I attended, I seem to remember a display of tools > > that contained a nice hardwood ball that will fit on the end on > > extension-type tuning levers. Does anyone know who makes these or where I > > can get more information about them? > > > > Thanks, > > > > Dave > >
This PTG archive page provided courtesy of Moy Piano Service, LLC