Hi Arthur, I am looking forward to trying it out. Do you have a time frame in mind. I'm thinking I may not be able to get right to it and report the results back immediately. Being down with the flu for 2 weeks really cut into my schedule. My own curiosity may get the best of me, however, and I may be able to sneak in some time in the next few weeks. jeannie -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of gutlo Sent: Thursday, January 11, 2001 6:27 AM To: pianotech@ptg.org Subject: ATTN; Dyna2 testers You should all be receiving your samples via FedEx by the end of the week. Following are some suggestions for your test: 1. Put on a very thin coat, let it sit for an hour. You might just take off the finish, leaving the paste wood filler. 2. Use only a natural bristle brush to apply. A nylon brush doesn't allow an even coat. 3. Don't forget to try it on a vertical surface - no drip or sag. 4. Wait overnight before sanding to prevent gumming up the sandpaper. Post your results on the list. Thanks for your time and trouble. Arthur Grudko StarHawk Labs
This PTG archive page provided courtesy of Moy Piano Service, LLC