Hi Richard, Those down weights are NOT heavy. Balance weights are "normal". I think you need to do a good regulation and then check things out. Take hammer shanks off and swing them. Just because you put dope in them don't assume they are high. Measure, measure, measure. Do the same for the wippen flanges. Pull a key sideways and move it up and down against the front pin. If you feel any drag at all you need to repolish the pins. > didnt look to closly at it cus there's > nothing I can do to change it anyways. That is not entirely true. Take a small piece of veneer and slip it behind the top of the wippen flange. This will increase the spread a little. Take up and down measurements carefully before and after. what you want is the narrowest difference between the U & D. If it disimproves then you are barking up the wrong rail. It is in the details that make the difference. Have a nice day. Newton
This PTG archive page provided courtesy of Moy Piano Service, LLC