List Consider this price $ 400.00 for say a complete set of stwy hardware quite PRICEY. Our local guy can do a set for 200ish. Check with the locals in your area. Dale Erwin ----- Original Message ----- From: "Nichols" <nicho@lascruces.com> To: <pianotech@ptg.org> Sent: Sunday, April 01, 2001 8:39 AM Subject: Re: hardware plating > Mark, > Our plating service in El Paso gives us a turn around of a couple of days > and does real nice work. Not been displeased yet. Pricey, though. Depending > on number of pieces, up to $400.00 for a real complete (every little thing, > kinda) job. Nice buffing, and out of 20-25 sets per month, only a few large > screw notch flakes. No lost parts (yet). > > Guy > > At 05:30 AM 4/19/01 -0400, you wrote: > >Greetings - > > > >Being a little less than satisfied with the hardware plating I have had > >done in the past, I was wondering if anyone has a place they would > >recommend as doing good metal finish work, preferably in a reasonable > >time frame. I know of several other finishers with the same interest. > > > >I see that there is an ad in the Journal from the Whitman Company > >offering metal finishing with a turn-around of 2-3 weeks. Has anyone > >used their services? > > > >Mark Potter > >bases-loaded@juno.com > >
This PTG archive page provided courtesy of Moy Piano Service, LLC