Leg plates are cast in pairs. If the new one is from a different casting lot they will likely not fit. I always replaced them in pairs. Just my opinion. Lots of luck. Newton David Ilvedson wrote: > > Newton, > > If you are replying to me, thanks, but I'm talking about the leg lock > plates...male on the leg and female in the case. I ordered one from Schaff > (nice of them to sell me one instead of the set) and will give it a try but > I think the "official" Steinway part might be better made? > > David I. > > > -----Original Message----- > > From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf > > Of Newton Hunt > > Sent: Sunday, October 08, 2000 7:00 PM > > To: pianotech@ptg.org > > Subject: Re: > > > > > > David, > > > > S&S legs are made of maple and most supply house legs are > > made of poplar or mahogany. > > > > Very likely you will have to replace all three legs to match > > size and shape. > > > > Take your wood and take your chances. > > > > Newton > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC