----- Original Message ----- From: Ron Nossaman <RNossaman@KSCABLE.com> To: <pianotech@ptg.org> Sent: March 08, 2000 5:17 AM Subject: Baldwins was Re: Pin Torque survey - results are in! > >you guys are wimps!! When I worked for Baldwin in the factory at Conway for > >12 years, the acceptable torque on a pin was between 180 and 230 lbs. , > >otherwise it was replaced with a bigger pin !!!!!! I guess that explains > >why I have had 2 cervical fusions and 2 degenrated discs in the lumbar . > >What do you guys think of the 6000? You know they are made in Greenwood ?? > >Shelley Wilson > > > I'm not sure which one that is, but I have some comments on the one Del > designed the back for. The Model 6000 is the 52" vertical and was designed by Harold Conklin. Del
This PTG archive page provided courtesy of Moy Piano Service, LLC