In a message dated 6/27/2000 11:10:18 PM, you wrote: <<"A friend ask if I could get the inf on how to change the batteries in her sat ll? Thank you I did look in the archives but could not find the one that gave detailed instructions, Pat">> Pat; As the most recent recipient of the lists generous assistance vis a vis SAT battery change...................... material needed: 4 AA NicCad batteries..600MAH or better. (use the best rating available) soldering iron solder adhesive (I used pvc-E) tape wire nippers 1. In each of the plastic connectors holding the unit together there is a 'pin' that needs to be pushed into the unit until it falls free. There are six connectors in all and the pins will need to be reused to put the connectors back in. 2. After all the pins have been pushed in remove the connectors and set aside. (I used a cup to hold the connectors and pins) 3. Pull the front of the SAT up and with a folding motion tilt it backwards until you find a resting place for it. (there are ribbon connectors that will prevent removing it entirely) 4. The batteries are glued to the bottom of the base and will need to be chisled/cut free. 5. Make note of which wire is fastened to positive and negative poles and snip wire leads. 6. Construct a new battery pack using solder and soldering iron. 7. Tape the batteries together tightly. 8. Resolder the wire leads. 9. Glue the battery pack in the same place as the old one was removed from. 10. After glue dries put the front back on and the connectors back in. 11. Charge your new battery pack.......................... I think that covers it. :-) jim b
This PTG archive page provided courtesy of Moy Piano Service, LLC