At 08:03 AM 06/10/2000 -0400, you wrote: > >snip< >My question is: What is the best way to get the epoxy into the bridge pin >hole. I have done the bass bridge and used West System epoxy applied with a >length of piano wire. I was able to make a minimal mess (just a little on >the top of the bridge at the hole edge upon application - easily wiped off >prior to pin insertion), but inserting the wire 3 to 5 times into each hole >to get enough epoxy in took me two hours to just do the bass bridge. >Terry Farrell Get a glue injector which is might be available where you bought the epoxy. Woodworking stores/catalogue, marina, etc. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@mediaone.net ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC