I don't think so. :-( Avery At 01:44 PM 07/26/00 -0700, you wrote: >Another way to get the key height spot on is to shim the key until it's >slightly on the high side and then remove material from the bottom of >the key by scraping or sanding. > >Tom > >Newton Hunt wrote: > > > > I stopped using those a few years back because my slowing > > fingers couldn't handle them well. It was faster for me to > > remove a .005" paper and put in a .007" paper, or the > > reverse, as needed. I still have some .002" balance rail > > papers which I like to use. When those are gone I will go > > back to the old switchero. > > > > Newton > >
This PTG archive page provided courtesy of Moy Piano Service, LLC