Hi Terry: Keep in mind that the SAT uses various higher partials to tune to over most of the keyboard. Only in the uppermost octave or two does it use the fundamental. So when tuning A4 with your SAT and observing the 5.8 cents in the display window, the SAT is indicating that the targeted pitch for the partial to which it is tuning is at 5.8 cents. You SAT manual will tell you exactly which partial it uses for A4. After you tune, turn your SAT off, turn it on, press the "tune" button, and see where your A4 is set. It will be very very close to 0.0 cents - because here you are measuring the fundamental now. If it varies slightly from 0.0, the manual details a simple method to offset the SAT to correct for any slight deviation. Do you have a manual? Terry Farrell Piano Tuning & Service mfarrel2@tampabay.rr.com ----- Original Message ----- From: <pianolover@worldspy.net> To: <pianotech@ptg.org> Sent: Sunday, January 30, 2000 2:43 PM Subject: SAT FAC numbers > hi all, > > > I just bought a used SAT II which has the FAC feature, but I'm a > little stumped. I set and stored my 3 FAC stretch numbers. After > that I strip muted my piano (Baldwin 40" console), and when I got > to A4, I noticed the cents deviation was 5.8! Souldn't A4 ALWAYS > be perfect at 440? So I went back and re-entered the FAC again, (i.e., > tuning one string of A4 while the SAT is at "A5 and Zero cents", > the up 1 octave to A6 on the SAT, then playing A4 again, but stopping the > dots with the cents buttons) but each time, A4 was diviating about > the same amount: 5.8 cents sharp. Is this to normal for a stretch > tuning? Can I adjust the SAT to 0.0 at A-4 WITHOUT throwing all the > other calculations for the stretch out of whack? BTW, my 3 stretch numbers are: > F3= 17.1 > A4= 5.8 > C6= 3.6 > > -16 @ A0 to +32.4 @C8 is the low/high stretch. > > > Thanks. > > Terry > > > ______________________________________________________________ > Get free Internet service and email at http://www.worldspy.com
This PTG archive page provided courtesy of Moy Piano Service, LLC