I haven't been able to find one large enough. Stores seem to only stock up to a #3. I purchased a straight blade screwdriver that had a 1/4" shaft, cut off the blade and ground the shaft down to a 3/16" square tip. It works very well. Some Willis pianos also had this type of screw. Terry Beckingham At 10:30 PM 1/20/00 -0800, you wrote: >Go to yourlocal hardware store. They come in several sizes. Probably >metric if on a Heintzman. > >Dale F > >On Fri, 21 Jan 2000 00:26:41 EST IgorKatz2U@AOL.COM writes: >> What is the term for the screws that have the square hole in them >> and >> where do you get the tool for turning them? Do any of the normal >> supply >> houses carry it? It seems to be a Canadian phenomenon. I've seen >> them in >> some other pianos but the Heintzman is put together entirely with >> them. Is >> the tool similar to an Allen wrench? >> >> David Porter >> St.Louis, MO > >________________________________________________________________ >YOU'RE PAYING TOO MUCH FOR THE INTERNET! >Juno now offers FREE Internet Access! >Try it today - there's no risk! For your FREE software, visit: >http://dl.www.juno.com/get/tagj. >
This PTG archive page provided courtesy of Moy Piano Service, LLC