Wurlitzer Harmonics

[Joe & Penny Goss]

Richard,
Thanks for the plug <G>
Baldwin is using the "level" prior to damper installation to cut down on the
time needed to eliminate damper noises as well as other voicing problems.
THOSE INTERESTED MAY VIEW THE TOOLS AT
http://www.primenet.com/~imatunr/
Joe Goss
----- Original Message -----
From: Richard Oliver Snelson <rsnelson@dave-world.net>
To: <pianotech@ptg.org>
Sent: Friday, February 18, 2000 12:39 PM
Subject: Re: Wurlitzer Harmonics


> I have just gone through this on a new Wurlitzer Grand. On this one the
> string were not level from the factory. Start there. I took the upper
> dampers out down past the flat dampers. I used a brass rod with a notch
> (from Joe Goss) in it and first pushed the strings down from above
> (about 1/8"). Back of the bridge also. Then pushed them up equal from
> below, where I could reach. Then using Joe Goss's little brass leveling
> tool I sat it on the strings and found which one didn't touch. Continued
> to work till they were all level. Checked the hammer to string contact.
> Returned the dampers, retuned and the 8-9 problem notes were fine. C5
> was still causing a problem as I played across it. Two notes above to
> one below. I would hear the chirp as the C played. Turned out it was the
> note above, it chirped as the damper landed. I retuned that note's
> unisons and no longer hear the chirp.
>
> Best of luck.
> Rich
>
> I also thought the problem was from the dampers and had new Yamaha felt
> to install. It wasn't.
>
> > "Dan Hallett Jr." wrote:
> >
> > Dear List:
> >
> > I service regularly a Wurlitzer 5'3" Grand (S.N. 68408, purchased in
> > 1998) that has very heavy usage. Regularly their are audible harmonics
> > (the owner calls them 'hummings') caused by leaking bass dampers.
> > After regulation the audible harmonics are gone, only to reappear in a
> > few weeks.
> >
> > Has anyone else run into this? I'm ready to start replacing damper
> > felt, I think, unless there is another solution I'm missing. The
> > dampers can  be the same or different than those previouly re-
> > regulated.
> >
> > Thanks in advance for any suggestions.
> >
> > Dan Hallett
> >
> >
>