Hi Peter, The Renner hammer boring jig, I think it is only available from Renner USA. Some one will correct me if I'm wrong, but I think it was developed by the old Mason & Hamlin Co, Worth every penny. Roger At 06:36 PM 12/16/00 +0100, you wrote: > >Friends, > >Who can help me with this problem: setting and boring the angle (left-right) >of hammers for boring is no problem. But boring a whole set of hammers with >the same angle for and after so the strings are touched with 90 degrees, is >not easy. Who can tell me a simple way to guarantee all the hammers receive >the same angle for and after? >Thanks > >Peter Kestens (Belgium) >
This PTG archive page provided courtesy of Moy Piano Service, LLC