Don, I still don't understand why you're asking the question. Paul Don wrote: > Hi Paul, > > Would there be any point in setting a precalculated over pull to zero > percent? I can't think of any reason to do so. Can you? > > At 08:17 PM 12/03/2000 -0800, you wrote: > >Don't understand the question. > > > >Paul > > > >Don wrote: > > > >> Hi Paul, > >> > >> Over pull is user defineable on RCT so 0% is possible (but why?) > >> > >> At 07:34 AM 12/03/2000 -0800, you wrote: > >> > The percentages can also be tweaked for the technician's individual > >> >tuning style. If there is a risk of string breakage, I often use the > fine > >> >tune mode to get it close to pitch without overpull, then use the pitch > >> >raise mode as a final tuning. Paul S. Larudee DGPEAKE@AOL.COM wrote: In a > >> >message dated 12/2/00 12:23:06 PM Pacific Standard Time, > >> >larudee@pacbell.net writes: > >> > > >> > Agreed, but there is a big difference between having no problem and > >> having > >> >a pitch raise so accurate that all it needs is a little touchup. Paul S. > >> >Larudee > >> >Richmond, CA DGPEAKE@AOL.COM wrote: I believe the overpull is 25% of the > >> >2nd partial. Someone please correct > >> >me > >> >if I am wrong. (Jim, please pitch in). The SAT 3 is the same. I usually > >> >measure the lowest note of the plain wire, offset for pitch raise, and > >> > I have no problems with doing a pitch raise using this method. Dave > >> >Peake, RPT > >> >Portland Chapter > >> >Oregon City, OR > >> >www.davespianoworks.locality.com > >> > > >> > > >> >Really? 100% of the time? Yes, sometimes it is so close that I hardly move > >> >the pins. Other times it is still a little flat or a little sharp. Dave > >> >Peake, RPT > >> >Portland Chapter > >> >Oregon City, OR > >> >www.davespianoworks.locality.com > >> > > >> > >> Regards, > >> Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. > >> > >> Tuner for the Saskatchewan Centre of the Arts > >> > >> drose@dlcwest.com > >> http://donrose.xoasis.com/ > >> > >> 3004 Grant Rd. > >> REGINA, SK > >> S4S 5G7 > >> 306-352-3620 or 1-888-29t-uner > > > > > > > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. > > Tuner for the Saskatchewan Centre of the Arts > > drose@dlcwest.com > http://donrose.xoasis.com/ > > 3004 Grant Rd. > REGINA, SK > S4S 5G7 > 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC