Thanks Susan, I also wonder about using better quality fast drying lacquer and it's effects. Where do you get ultrablonde flakes? Is that what Pamela Anderson is??? I dated a flaky redhead once.. long story. Are ultrablonde flakes like the reddish brown stuff I have but purer somehow like different qualities of hide glue? Sorry 'bout the Pam joke, I couldn't resist. %~) Lance Lafargue, RPT Mandeville, LA New Orleans Chapter lafargue@iamerica.net -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of Susan Kline Sent: Tuesday, August 29, 2000 12:18 PM To: pianotech@ptg.org Subject: Re: Lacquer for hammers Hello, Lance >1) Why do some techs use sanding sealer instead of nitrocellulose lacquer? >Does it matter? I think it does, but don't have the experience to say for sure. The keytop in acetone sound is so obviously "noisy" and so hard to reverse that I've started trying ultrablonde shellac flakes in ethyl alcohol, and so far I like it. If anyone else would like to experiment with it, too, I'd be glad to hear about their results. >2) What is some advice you can give me on transfering the lacquer/thinner >from gallon can to a bottle for use. If you are transferring a small amount of anything from a large container to a small one, one method to use is to take a soda straw of appropriate diameter, dip it into the large container, put your finger over the top end, move the straw to the small container, and take your finger off. Like using a pipette in a chem lab to transfer small amounts of liquid. >3) What kind of bottle do you use? I use an eyedropper bottle, which originally held an herbal tincture. It seals well, and is the right size. The eyedropper is fairly easy to control, for applying. Of course you should label it, but shellac and ethyl alcohol aren't so toxic that a mistake would cause harm. > How long must it dry? Surprisingly enough, shellac didn't take all that long to dry, though it continued to get harder the next day. I used the "Everclear" 190 proof alcohol, so there was very little water to evaporate, and I mixed it up fresh. Old shellac has a harder time drying. > Do you ever put it on the strike point? Yes > What ratio? 4:1? 5:1? Still working out the ratios. > How long will it last after mixing sitting in the back of my truck? Probably depends on how good a seal the bottle has, but shellac shouldn't be kept for long. A dropper bottle is small enough that maybe it could come inside with you. Susan Kline
This PTG archive page provided courtesy of Moy Piano Service, LLC