As far as I remember, the regulation procedure is much the same as for a regular acoustic piano, with only a couple of exceptions: 1) check that the volume control is set to normal or above (with the power on). 2) strictly follow the procedures for regulating the pedals. 3) on all disclavier models the electronics should be reset each time after a regulation. Off the top of my head I forget the procedure, but it is something like going into maintainence mode, then ...? Perhaps some one on the list can remember, or I can try to dig up my references on this. I hope this helps! Larry Beach, RPT Vancouver, BC, Canada At 09:18 PM 27/08/2000 -0400, you wrote: >I tuned this bird a few days ago and the hammer shanks were much above >those round barrel-shaped, spring-loaded rest rail thingees. > >I turned down the capstans so that the shank just rested upon the barrels >giving slightly more than 1-3/4" blow. Was this correct procedure? > >John Lillico, RPT >Oakville, Ontario, Canada > >
This PTG archive page provided courtesy of Moy Piano Service, LLC