Carl, He does. He drives with the windows down O:( Joe Goss ----- Original Message ----- From: Carl W. Meyer <cmpiano@earthlink.net> To: <pianotech@ptg.org> Sent: Friday, August 11, 2000 12:00 AM Subject: RE: Lanolin for Hard Hammers > Larry! Your post conjured up some pretty bizarre images. I recall a > cartoon of a guy at a door telling a lady "Ma'am, we not only cut your > grass, but we also apply fertilizer." There is a few sheep in the back of > his truck. > > My question is "Where and what kind of lanolin do you get for this job or > do you take your sheep with you? > > I'm surprised you don't have your own hair drier. > > Just kidding. > > Carl Meyer > > > > [Original Message] > > From: Larry J Messerly <prescottpiano@juno.com> > > To: <pianotech@ptg.org> > > Date: 8/7/00 3:45:47 PM > > Subject: Lanolin for Hard Hammers > > > > Over two years ago, I was faced with a set of hammers on an old piano > > that would not "voice" using needles. (No, I didn't try steam.) > > > > I figured that they would not respond to the needles because it was like > > putting holes in cardboard. Didn't change the overall hardness at all. > > > > At no expense to the buyer of this piano, since this was untried, I > > coated the surface of the hammers with lanolin and "melted" it in with my > > daughter's hair drier. > > > > I now feel that this was a low cost success. I just tuned the piano last > > week and the hammers still have a nice tone and range of tone. > > > > FWIW > > > > Larry Messerly, RPT > > Prescott/Phoenix > > a real "Bald-0ne" > > > > --- Carl W. Meyer, Santa Clara, Ca. > --- cmpiano@earthlink.net > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC