Looks like good info here Roger, but can you clarify for us of so little knowledge??? :-) Lance Lafargue, RPT wrote: "How do you decide what height new backchecks should be installed?" Roger Jolly responded: "A rule of thumb for checking height." (Do you mean backcheck installation height or hammer checking height?) "A Jollyisum, Divide the check length into thirds" (The backcheck tall dimension?) ", with the hammer at the desired height" (The desired hammer checking height?) ", the centre line of the shank should line up with the top one third point of the check." (Do you mean 1/3 of the way down from the top of the backcheck?) "With the radius of the tail that I previously described it works every time." > Regards Roger Sorry Roger for the nit picking, but I value your input greatly, this sounds like good stuff, and I want to make sure I understand exactly what you are describing. Thanks for caring and sharing. Terry Farrell Piano Tuning & Service Tampa, Florida mfarrel2@tampabay.rr.com
This PTG archive page provided courtesy of Moy Piano Service, LLC