Hi John and Roger. I have to jump on this one since I had the problem here in Sherbrooke with most of the U1. If you look carefully at what stops the lip, you will find a small rubber button... With time, it will compress and that will change the angle at wich the lip comes to rest. I found that just adding a little piece of black stained leather on top of the button will restore the original angle of the lip. Of course, a better solution would be to order the button from Yamaha, but, on the spot, the leather does a fine job. No complaints yet. Marcel Carey, RPT Sherbrooke, QC ----- Original Message ----- From: John Lillico, RPT <staytuned@idirect.com> To: <pianotech@ptg.org> Sent: Tuesday, April 18, 2000 11:51 PM Subject: Re: Disklavier Music Support > Roger, > > But how can the hinges get bent from books resting on the lip. Are you telling me that someone forced the lip closed with something obstructing its movement? What a stupid design !! > > John Lillico, RPT > Oalville ON Canada > > >Hi John, > > If it's a U1, I'd bet on the hinges. > >Roger > > > > > >At 02:19 PM 18/04/00 -0400, you wrote: > >>Yamaha techs or dealers, > >> > >>Can you tell me what supports the music holder on a Disklavier upright? > >> > >>A college reports that books and sheets slide off their music desk "lip". > >They describe the "lip" as being on a plane with the keys (if that's what I > >mean), so I assume there's something missing where the inside rear end of > >this folding lip engages the fallboard when in use. > >> > >>Or, could it be bent hinges? > >> > >>Any suggestions before I take a long hike? > >> > >>John Lillico, RPT > >>Oakville ON Canada > >> > >Roger Jolly > >Saskatoon, Canada. > >306-665-0213 > >Fax 652-0505 > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC