Wouldn't the tuning pin bushings help to restrict motion? I would try snugging the plate screws and inserting hardwood wedges between the flange and block to see if it makes a difference. Jon Page At 10:15 PM 3/19/99 -0600, you wrote: >Greetings from the rapidly thawing Canadian prairie! > >Further to the discussion on pinblock fitting, could someone comment on >Yamaha's official position on this issue? A colleague of mine has a client >whose C3 has a gap between block and flange tapering from 33 thou in the >bass to about 11 thou in the treble. The piano apparently suffers from >tuning instability despite proper humidity control (Dampp Chaser) and >frequent tuning. > >When brought to Yamaha's attention, the official factory response was that >the gap was "within tolerance". Is there such a tolerance for pinblock >fit? To me, it either contacts the flange or it doesn't. > >Regards to all, > >Stan Kroeker >Registered Piano Technician >
This PTG archive page provided courtesy of Moy Piano Service, LLC