---------------------- multipart/alternative attachment What kind of drill are you using? (i.e. electric hand drill?) May I suggest using a Fordom high-speed unit with a long flex cable. The speed will be to your advantage in piloting the hole. Rob Goodale, RPT Brian Trout wrote: > For those of you who make bridges, I'd like to hear what > kind of drill bits you're using to drill the bridge pin > holes, and the technique you use. Here's what I've been > doing. I've been laying out the pattern on the fresh cap, > marking it fist with a pencil mark, and then with a very > sharp awl (not deep, just a mark I can see, perhaps 1/32" > deep), and proceeding to drill with the standard drill bit > from Apsco, by hand. What can I do to keep the wandering > bit to a minimum? ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/98/dd/e3/a8/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC