Chris - If you have access to a lathe, you could glue up stock to sufficient size and turn a plug very quickly. I would epoxy it in. Mark Potter bases-loaded@juno.com On Fri, 10 Dec 1999 12:53:16 -0400 "Christopher D. Purdy" <purdy@oak.cats.ohiou.edu> writes: > last night i found one of our yamaha verticals limping. > when i put it on it's back i found that the screws holding the caster > sleeve were not only striped out but the wool around them was destroyed also. i > have no choise but to drill it out and plug but i have never had to plug > a hole this big, like over two inches in diameter. i have a hole saw that > will make a pretty hole but how do i make a plug to fit? > chris > > -Christopher D. Purdy R.P.T. School of Music Ohio University > Athens OH > > -purdy@oak.cats.ohiou.edu (740) 593-1656 fax# (740) 593-1429 > >
This PTG archive page provided courtesy of Moy Piano Service, LLC