Bill: There is not enough clearance to get the pins in. I tried that. So I'll have to use your second suggestion. Many thanks to you and the others who responded! Clyde Hollinger, RPT Lititz, PA axpiano@aol.com wrote: > > In a message dated 98-07-17 17:07:30 EDT, you write: > > << Do I need to remove all the keys and slip them back in place one at a time? > >> > > I've run into a few of these, and have put the actions back in with the keys > in place. If I remember correctly, there was enough clearance to get the pins > in. > > In reinstalling the action, go in just low enough to let the pins drag on the > key rockers while swinging the bottom of the action back into place. See if > lifting a wippen gives enough clearance to slip the pin in. If the pin is too > long, lift the key clear of the balance pin, pull it toward you and you will > have room to get the pin in. > > Bill Maxim
This PTG archive page provided courtesy of Moy Piano Service, LLC