> I recently replaced the springs on a Kimball...It was rather quite >simple...used a small standard screw driver...It took about 30 minutes, >including >removal and installation. > The spring tension is going to be much stronger in the new springs and >will need to be regulated. I do a rough pass with the rail on the bench. >I think that it goes much faster to do a rough pass then a fine >regulation with the action in the piano... > >Mike Masters Thanks for sharing your method, Mike. Using the screwdriver is probably a little safer than my paring knife idea. :-) Keith A. McGavern kam544@ionet.net Registered Piano Technician Oklahoma Chapter 731 Piano Technicians Guild USA
This PTG archive page provided courtesy of Moy Piano Service, LLC