Good points, but remember to trim the wafer to fit in order to maintain ivory alignment while clamping. Jon Page At 09:09 AM 4/6/98 -0600, you wrote: >David, > I use the instructions that come with the ABSCO wafers. > "Prepare work same as for liquid glue. Immerse sheet glue in water >half a minute and apply to wood. Place ivory then apply plate as hot as >possible to handle with fingers and draw up the clamp. Allow 30 to 45 >minutes to dry. Plate may be heated with a spirit lamp after applying to >the work if desired" > I use one of those mini propane torches instead of the spirit lamp >for heating the plate for about ten seconds , just long enough for the glue >to start to flow, and then tighten the clamp again. Works great and there >is no need to leave the clamp on for 24 hours. > >Chris Gregg
This PTG archive page provided courtesy of Moy Piano Service, LLC