Yo Bob & Mark. If my memory serves, it is 7/32. But if you're desperate, a common slotted screwdriver will often do the trick, and I doubt you'll see enough of these to warrant buying one just for that purpose. Steve >>> Mark Story <mstory@ewu.edu> 09/08/97 09:31am >>> Hi Bob, They're not metric, they're SAE. I'm curious - what made you assume that they are metric? All of these that I have run into are domestic. Mark Story, RPT Eastern Washington University mstory@ewu.edu ---------- > From: robert sadowski <rls@ncinter.net> > To: pianotech@ptg.org > Subject: Everett key > Date: Monday, September 08, 1997 8:21 AM > > Dear List, > What size Allen key fits the rounded screws on the back of the Everett > verticals > that hold the top on? I'm assuming it's metric. I've tried two different > sizes of metric
This PTG archive page provided courtesy of Moy Piano Service, LLC