List, While rebushing a set of keys to a 20 yr old Baldwin 6'er, I noticed the pin was rubbing on the keystick below the bushing. I removed some wood with a bit in my Dremel tool and rebushed. I also noticed the hole in the button was off center and looked at the balance rail pins; they too mostly leaned to one side. As if they'd been left out in a high wind for a while. What can of worms is awaiting me if I replace the buttons and straighten the pins? Or will it just relieve some of the friction left-over after repinning the flanges. Also, which rig is best for this button replacement? I have others to do in the near future. Thanks, Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC