Ron, The bottom edge of the sos. in the rest position should be 1/8" higher than tabs. Measure tab height from keybed, dd 1/8" for bar height, either shim brackets or bend with pliers. When engaged, The tabs should be 1/16" onto sos. bar, to adjust tab depth, move brackets with screw/slide adjustment. I also like to give the sos. pedal the same travel as the damper pedal. Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) >~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ >List, > I really thought that this mystery #4 was over. Steinway L, >damper job went well. I just got an email stating that the sostenuto >doesn't work. I took a quickie look but to be honest with you I didn't >have the time. The sostenuto lever is now higher than the tabs. > Are there some screws on the back of the action I can loosen and >then just slide the bar down a little? What's the correct adjustment? >Thanks, > >Ron Shiflet > > Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC