I am about to install a set of dampers with new wires on a grand piano. The only time I replaced wires before this, I used the old wire bends to get started with the new wires and went from there, but the existing wires on this piano have been so abused I can't really use them as samples. Is there a Journal article someone can point me to, or your own method you can share with me as to how to determine the initial bends and install the felt? Are the bends established with no felt on the head and then the felt glued in place? Thanks for any input. Jeff Stickney, RPT University of Montana jpage@selway.umt.edu
This PTG archive page provided courtesy of Moy Piano Service, LLC