Hi Paul, Thanks. I was at Oberlin at the same time as you. I wasn¹t in on the damper guide rail reproduction class, but I had it at Steinway with Kent Webb. I failed to write down the drill bit size. Thanks again, Jeff On 6/23/10 2:51 PM, "Paul T Williams" <pwilliams4 at unlnotes.unl.edu> wrote: > Jeff, > > Ken Sloane at Oberlin at the Steinway seminar had us make a new guide rail > from scratch two years ago. My project was also a B. We used a #15 drill bit > for the main hole, then also put a counter sink hole on both sides for the > felt to open up on both sides. We used no glue to install, just pull them > through and trim up to look good. Then just used the pi-r-square to figure the > radius for cutting the right felt width. I think 5/8" was about right. I > think all the Steinway guides have the same damper wire widths. > > Hope this helps > > Paul > > > > From: Jeff Farris <Jfarris at mail.utexas.edu> > To: "caut at ptg.org" <caut at ptg.org> > Cc: tseay2 at austin.rr.com > Date: 06/23/2010 02:32 PM > Subject: [CAUT] Damper guide rail holes > > > > > Hi List, > > Anyone know what size drill bit to use for drilling new damper wire guide rail > holes for a Steinway B? Or where to find out? > > Thanks, > Jeff Farris > > Jeff Farris > Piano Technician > School of Music > UT Austin > jfarris at mail.utexas.edu <jfarris at mail.utexas.edu> > 512-471-0158 > > Jeff Farris Piano Technician School of Music UT Austin jfarris at mail.utexas.edu 512-471-0158 -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20100623/3f589dc3/attachment-0001.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC