That's great...and plain steel screws, which Bolt Depot did not have. I wonder if these plain steel are the same as the American Piano Supply screws? David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: "David Stocker" <firtreepiano at hotmail.com> To: caut at ptg.org Received: 6/3/2009 9:18:56 AM Subject: Re: [CAUT] Yamaha grand screws too short? >http://www.mcmaster.com/ >Huge, but easily searchable online hardware catalog. Recommended to me by >Del Fandrich. >Dave Stocker >Tumwater, WA >-------------------------------------------------- >From: "maxpiano" <maxpiano at sc.rr.com> >Sent: Monday, June 01, 2009 5:53 PM >To: <caut at ptg.org> >Subject: [CAUT] Yamaha grand screws too short? >> A church I serve has had the piece that holds the lock to the lid on their >> Yamaha C7 pull loose. (I know, I know--after 50+ years tuning, I should >> know the name of the piece. The book on nomenclature is next on my list >> to get). I have never run up against this before. But the screws (2 >> 7/16" flat head brass--#12?) do not protrude much into the lid and I'm >> wondering how well my standard fix for stripped screw holes (leather >> lining the hole) will hold unless I can find a slightly longer screw. Is >> any such screw available -- perhaps 1/8" longer? I fear the point >> pricking the finish of the other side if I go too long. >> >> Bill Maxim >> >> >> >>
This PTG archive page provided courtesy of Moy Piano Service, LLC