[CAUT] lubing ponder

[Jim Busby]

Hey Wim,

Was this before you went to Hawaii or after? <G>

Best,
Jim

From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of wimblees at aol.com
Sent: Tuesday, August 18, 2009 12:19 PM
To: caut at ptg.org
Subject: Re: [CAUT] lubing ponder

My dad taught me to pull a center pin through my hair prior to using it. Even when it's clean, there is enough oil in your hair to make the pin a little more slippery.
Wim

-----Original Message-----
From: G Cousins <cousins_gerry at msn.com>
To: CAUT <caut at ptg.org>
Sent: Tue, Aug 18, 2009 3:45 am
Subject: [CAUT] lubing ponder
Gang,
Pondering......
Has anyone ever considered pre-treating the pins (action not tuning)prior to repinning?
Perhaps just a shot of spray or putting the pin a bath.. CPL/Pro-Tec etc. before inserting.
May or may not have benefit for long term. Yes, some bushing is graphite enhanced but most is not.
Looking forward to discussion pros and cons.
Gerry C
West Chester University of PA

=
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/caut.php/attachments/20090818/a690672d/attachment.htm>