[CAUT] pin-block plugging?

[Mark Cramer]

Thanks John,

 

I think the hole-boring, bit-sizing, feed-rate thing is likely okay, as it's
the same regimen we use for boring new blocks and the results are what they
need to be.

 

I think I'm doubting the strength of that thin layer of wood, and the glue
joint. maybe I need to let that glue cure for several days?  

 

Anyhow, you've had good success with spot-plugging John?  No need to up-pin?

 

Best regards, 

Mark C.

 

PS Hi Wim, I did try a resin repair on a pin-block back when this was being
promoted (maybe in the late 80's?), but haven't since for the reasons you
describe.

 

  _____  

From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of John
Ross
Sent: April 30, 2009 11:27 AM
To: caut at ptg.org
Subject: Re: [CAUT] pin-block plugging?

 

The glue should have nothing to do with a hole being too large.

Bad glue would cause the plug to become loose.

Webb Philips has a glue he sells to put in the plugs.

If you have to use a #2 pin in a hole you say was drilled for a #1, then
either you are using the wrong size bit, or your drilling speed is wrong.

I have found Ron Nossaman's double drilling with two different size bits to
work well.

John Ross

Windsor, Nova Scotia.

----- Original Message ----- 

From: Mark Cramer <mailto:cramer at brandonu.ca>  

To: CAUT <mailto:caut at ptg.org>  

Sent: Thursday, April 30, 2009 1:12 PM

Subject: [CAUT] pin-block plugging?

 

Now and then I run into a situation where plugging a tuning-pin hole and
re-drilling seems like the only option. IOW, neither an over-sized pin, CA
glue nor an emery paper shim will work.

 

I've tackled this fairly carefully, even using a small portable drill press
clamped to the keybed to get a precise hole, but I never seem to get a good
result:

 

I've used plugs from both economy blocks and Bolduc blocks. The plugs are a
tight fit to the wood, and really have to be driven home. I've used
carpenter's glue.

 

Nonetheless, the results always seem to end up the same. I bore for a 1/0
pin, then end up installing a 2/0, then up-sizing to a 3/0, and often a
4/0!?

 

Anyone have success with this? 

 

Over the years some of you must've plugged and re-bored entire pin-blocks.
What's your secret?

 

Thanks,

Mark Cramer, RPT

Brandon University

 

 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/caut_ptg.org/attachments/20090430/89abc53a/attachment.html>