If no one has an answer, I would suggest test drilling and tapping in a piece of plexiglas. Ed S. ----- Original Message ----- From: Jim Busby To: caut at ptg.org Sent: Thursday, November 06, 2008 12:52 PM Subject: [CAUT] Drill bit for agraffes All, With a stripped 7/32 agraffe can I drill and replace with ¼ agraffe? What size drill bit would I use if drilling a new hole for a ¼ inch agraffe? Or, would I simply use the ¼ inch tap? Thanks. Jim Busby -------------- next part -------------- An HTML attachment was scrubbed... URL: http://ptg.org/pipermail/caut_ptg.org/attachments/20081106/34034460/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC