Paul, The S&S dip block that I got at the factory in February is .400 in. and we regulated the pianos to be from .400 to 410. But the concept is to set it at whatever works that isn't too much or too little. :<) jeannie _____ From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Jim Busby Sent: Thursday, May 22, 2008 1:14 PM To: College and University Technicians Subject: Re: [CAUT] caut Digest, Vol 1110, Issue 48 Paul, I got the new S&S manual and it says .400. It also said something that surprised me, although I kind of though this all along; "It should be noted that the key dip may vary within the suggested range of .390 to .420 inches for any Steinway grand piano." Cheers, Jim _____ From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Paul T Williams Sent: Thursday, May 22, 2008 2:00 PM To: College and University Technicians Subject: Re: [CAUT] caut Digest, Vol 1110, Issue 48 Hi Richard, I think the key-dip on a D should be more like .390". Try that. Paul "Richard Adkins" <RADKINS at coe.edu> Sent by: caut-bounces at ptg.org 05/22/2008 02:52 PM Please respond to College and University Technicians <caut at ptg.org> To <caut at ptg.org> cc Subject Re: [CAUT] caut Digest, Vol 1110, Issue 48 I have a new bag of PU-12W Wurzen "Tapered" Front Rail Punchings I got from Piano Tech. I plan to try them on a S&S D this summer. You can tell the correct orientation, as some thoughtful person has put a nice black line on the side that goes bottom down. But it is easy to see on the bench, which is which. On this S&S D w/.400" key dip, the jack touches the felt in the jack (fly) window. I'll be checking the entire action geometry. Perhaps it could use a shallower dip, but I don't want to compromise there if I don't have to. This is a 1940 vintage. Perhaps key dip was shallower? String height: Note 62 is post on at 7 5/8" 36 is 7 3/4 (natural crown?)...I've seen the string height drop dramatically here in winter! 1-20 are about 8" (from the middle of the string diameter) These problems have been discussed this past year, giving me the urge to revisit this action and try to improve it. I did raise up the rear of the stack some a few years ago, but maybe not enough. The distance from the shank to rest felt was way, way to large. Thanks to the kind souls on this list for publishing Mike Mohr's forefinishing notes. Anyhow, I need to do some more head scratchin'....take a lot of measurements again. I'm hoping the Wurzen felts will help too! Richard Adkins Coe College -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/20080522/d056f879/attachment-0001.html
This PTG archive page provided courtesy of Moy Piano Service, LLC