Hey Elwood & David, I'll try to get pictures, not much of a photographer.... DP -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Elwood Doss Sent: Thursday, May 15, 2008 3:33 PM To: College and University Technicians Subject: Re: [CAUT] buzzing truck Hi Dale, Got a photo of the vertical brace? I'd like to see what you've done. Joy! Elwood Elwood Doss, Jr., M.M.E., RPT Piano Technician/Technical Director Department of Music 145 Fine Arts Building The University of Tennessee at Martin Martin, TN 38238 731/881-1852 FAX: 731/881-7415 HOME: 731/587-5700 -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Ward & Probst, Inc Sent: Thursday, May 15, 2008 3:18 PM To: 'College and University Technicians' Subject: Re: [CAUT] buzzing truck Dave, Wheels wear out, trucks usually don't. We install a vertical brace between the truck plate and a bean to stiffen the assembly. Anecdotal reports are that it improves the touch and tone. The brace is black pipe cut and threaded to size with floor flanges fastened to the parts at each end. HTH, DP Dale E. Probst, RPT Ward & Probst, Inc. Wichita Falls, TX mailto:dale at wardprobst.com www.wardprobst.com -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of johnsond Sent: Thursday, May 15, 2008 10:03 AM To: College and University Technicians Subject: [CAUT] buzzing truck Hi all- The truck on our #2 performance piano has a problem buzz. It has been elusive for some time mostly because it's been difficult coordinating the occurrence of the buzz with someone else available to play the note while I check things out. This finally happened yesterday. All bolts are tight. When we play a Bb there is a buzz coming from somewhere between the top and bottom center plates. Laying only the weight of my hand on the top plate makes it stop, remove my hand and it comes back. It does not sound like any stray material is inside but it will not be possible for me to remove the truck until summer sometime. What I did was loosen the suspicious bolt about half way which allowed the plates and arm to reposition slightly, then re tighten. I have not been able to make it recur since then. It is a standard Colson truck from Jensen's that I guess is about 15 years old. I am inclined to recommend just replacing the whole truck as I was expecting to replace the wheels anyway this summer. As anyone else experienced a similar problem with a truck? How long do you typically keep them on performance pianos? Any other suggestions.....? It needs to be resolved with confidence. thanks, Dennis Johnson St. Olaf College
This PTG archive page provided courtesy of Moy Piano Service, LLC