The belt sander I use runs at 1725 RPM, 3000SFPM. With any care at all and a glass of water (only needed sometimes) heat is not a problem. Tim G On Aug 5, 2008, at 9:33 AM, Paul T Williams wrote: > > What RPM does it run at? > > PW > > > > Tim Geinert <geinert at drtel.net> > Sent by: caut-bounces at ptg.org > 08/05/2008 09:25 AM > Please respond to > College and University Technicians <caut at ptg.org> > > To > College and University Technicians <caut at ptg.org> > cc > Subject > Re: [CAUT] Work Sharp > > > > > > Paul, List > > You might also wish to look at the Surgi-Sharp system sold by Wapin > Company. > http://www.wapin.com/SurgiSharp_1.htm > It is for a 1x30 or 1x42 benchtop sander that is common and > usefull, is extremely versitile(knives and such are easy) and > sells for only $60 with shipping. > > Tim G > > On Aug 5, 2008, at 8:33 AM, Paul T Williams wrote: > > > Hi List, > > I just found out about a great tool sharpening tool at > www.worksharptools.com Check it out! It would save hours > sharpening chisels, etc. and not too spendy. > > Paul > > -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/20080805/6ebad6ef/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC