---------------------- multipart/alternative attachment In a message dated 10/19/02 12:55:35 PM !!!First Boot!!!, a440@optonline.net writes: > Wim, > > Check the flange and balancier pinning friction, if too high the amount of > rep spring tension needs to be higher to get hammer rise, resulting in the > "bobbling" problem. I'd be afraid that with little or no hammer rise you > might run into rep problems or worse, a dead key! > > David Denison, RPT > Long Island, NY > Nassau Chapter-Piano Technicians Guild > > Dave As a matter of fact, that was one of the first things I checked, when I had trouble with the rep springs. I only did a few of the "bad" ones, and found the pinning to be correct. Thanks for the suggestion, though. Wim ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/46/bd/68/3f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC