Hi, Paul, David Vanderlip did a number of these at Pomona College some years back. If memory serves, he worked out a pretty slick method for this gig. He is in the guild directory; and, I think his email is: dvanderlip@compuserve.com but am not sure. Probably best to phone him. Hope this helps some. Best. Horace At 04:20 PM 1/29/2001 -0500, you wrote: >Hi, >Anyone have a set of hammer butts for a 1098 circa 1968 (Pratt Whitney). >Or for that matter, has anyone had any luck changing these parts, and if >so what are you using and where can I get them. I am going to need to >replace the hammers, shanks and butts. > >Regards, >Paul > >Paul Kupelian, RPT >Oswego State University (Ret.) >kupelian@oswego.edu ********************************************* Horace Greeley, CNA, MCP, RPT Systems Analyst/Engineer Controller's Office, Stanford University 651 Serra St., RM 100 Stanford, CA 94305 Voice: 650.725.9062 Fax: 650.725.8014 *********************************************
This PTG archive page provided courtesy of Moy Piano Service, LLC