Straight flute reamers - was Gun Brush Size

[John Baird]

Check in the July 1991 PTG Journal, page 10, for info on straight flute
reamers.

The letter (I.) reamer, diameter .2770 part #EDP30820 works well for the
3/O tuning pins. The letter (K) to be used for 4/O pins part #EDP30822
with diameter
.2820.

These tools can be ordered through: Jack Benedict, Austin For Logan,
Inc.; 1500 Kenmore Avenue; Buffalo, NY 14226 (716) 875-3770 or FAX (726)
875-
8280 (this contact information is from the 1991 Journal, so it may not
be up-to-date).

John Baird

Jon Page wrote:

> At 03:54 PM 02/20/2001 -0600, you wrote:
> >List,
> >
> >Can someone tell me the size of gun barrel brush to
> >use to clean out tuning pin holes before restringing?
> >(Using the original block)
> >
> >Thanks.
> >Avery
>
> Avery,
>
> .030 caliber
>
> Jon Page