Hi Ron, I tend to take a minimalist attitude to installing a DC system. One hex knut driver, one slot screw driver, and a tiny hammer to pound in the push pins for the upright drier bars. For grands I add a small flash light. If I install a back cover on an upright I also carry a knife to trim to size--I use 6 mil builders plastic on the back. It is held in place with thumb tacks and duct tape. At 11:20 AM 08/12/1999 -0400, you wrote: >There are enough of you out there who install Dampp-Chasers on a fairly >regular basis. I wonder if you would share the content of your DC >installation toolkit - assuming you have a special box designated for >just that task - with those of us who are relative new-comers to that >facet of our work. > >Thanks in advance! > >Ron Torrella, RPT > > > Regards, Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. Tuner for the Saskatchewan Centre of the Arts drose@dlcwest.com http://www.dlcwest.com/~drose/ 3004 Grant Rd. REGINA, SK S4S 5G7 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC